How do I connect to Cisco E2500?
Configuration for Linksys routers: E1200, E1500, E2500, E3200, E4200, WRT160n
- Access the router’s browser-based utility. Log into your router’s browser-based utility by entering 192.168.
- Go to the “Setup” menu. Click on the “Setup” tab.
- Go to the “Basic Setup” page.
- Enter the first DNS resolver.
- Save your settings.
How do I find my Linksys E2500 hardware version?
The hardware version is located beside or beneath the model number and is labeled version, ver. or V. If there is no version number beside the model number on your Linksys product, the device is version 1.
How do I install Linksys software?
For instructions, click here.
- Go to the Linksys Support Site.
- Click on the DOWNLOADS / FIRMWARE button.
- Select the Hardware version of your device.
- Locate the Setup Software for your computer and click Download.
- Save the Setup Software and select a location on your computer to save the file.
How do I launch Linksys Connect?
Insert the Setup CD on your computer’s CD drive then click Run. NOTE: For Mac® computers, locate and double-click the icon. Then, locate and double-click on the Setup/Connect icon. This should start the Linksys Connect installation.
How do I connect to a Cisco device?
Step 1 Connect the RJ-45 end of a DB-9-to-RJ-45 serial cable to the RJ-45 Console port on the router. Figure 3-3 shows the RJ-45 end of the serial cable connected to the Console port on the router. Step 2 Connect the DB-9 end of the DB-9-to-RJ-45 serial cable to the COM port on your laptop or PC.
What version of Linksys Connect software does my Linksys E2500 come with?
What version of Linksys Connect Software does all Linksys E2500 versions come with and how do I install it? The Linksys E2500 version 1 and version 2 come with Linksys Connect Software version 1.3whereas the Linksys E2500 v3 comes with Linksys Connect Software version 1.5.
What is the management software for Cisco 2500 series wireless controller?
PI is the current management software used to manage the Cisco 2500 Series Wireless Controller. Earlier versions were called WCS or NCS. It provides advanced management tools like wireless coverage display and location-based services.
What are the Ethernet ports on the Cisco 2500 series used for?
Ethernet ports on the Cisco 2500 Series Wireless Controller should only be used to connect/uplink to an infrastructure network configured as a data interface (management interface and dynamic interfaces) or an AP-managers interface.
Does Linksys E2500 allow VPN tunneling using IPsec?
Does Linksys E2500 allow VPN tunneling using IPSec, L2TP, or PPTP protocols to pass through the router? Yes. 18. Does Linksys E2500 support Stateful Packet Inspection (SPI) firewall?