What does no LNB voltage mean?
If your controller display is showing No LNB Voltage then it’s not a problem with thecontroller or the data connection to the dish. It’s just that the LNB (the actual antenna on the arm on the dish) isn’t getting any voltage to power it up. Without voltage it won’t pick up any signals.
How do you manually stow winegard Trav ler?
To stow the unit when you are ready to travel: Press [Power] one time. The unit will stop what it is doing and begin to return to the stowed position. The TRAV’LER Interface WILL NOT TURN OFF unless the TRAV’LER mount is successfully stowed.
Why is my winegard not working?
Check that the coax cable is not damaged or corroded, run a temporary coax cable from the LNB to the TV through the door way or window of your vehicle, (if there is no improvement we know it is not the cable or the LNB angle, however it could be that the LNB is faulty, replace the LNB with one that has the same code.
Why is my antenna booster not working?
Signal boosters require very little maintenance, but it’s always possible that something has damaged one of the exterior mounts or cables on an antenna outside the building. It’s also possible an internal antenna has become misaligned or damaged as well.
Why are free to air channels not working?
First check that your TV is set to the correct Source or Input, try changing the Source or Input to AV, TV, Digital TV or DTV if you haven’t already. If your “No Signal” message is not due to incorrect Source or Input being selected, then it’s most likely caused by a set up or antenna fault.
Why my antenna is not working?
All you need to do is plug in or tighten the loose cable. Another reason why your antenna is not working because it is completely damaged. There are many things that can damage an antenna. These include bad weather, destruction by birds that land on it, worn out cables, among many others.
Why am I not getting any channels with my antenna?
The antenna may have difficulty picking up your favorite stations over the air for several reasons. The causes mostly come down to the basic idea that the signals reaching the device aren’t strong enough. You may be too far from the broadcast location, or something physically blocks the signals.