How long does it take for a screen protector to dry?
Step 8: Allow the screen protector to rest for about eight to 12 hours or until fully dry.
Do you put screen protector on before case?
We recommend that the screen protector be applied while the case is on the device to ensure that the screen protector is precisely centered and aligned for proper installation. Before beginning, make sure to wash your hands thoroughly and wipe your screen with the microfiber cloth and the included screen wipe.
Where do you put guide stickers?
Place the “guide stickers” to the side of the screen protector and around the edge of the device so that the stickers will function as a hinge. Confirm that the screen protector can “open” and “close” (similar to a door) and that the edges of the glass are still aligned with the edges of the device.
How do you use screen dust absorption sticker?
Use the dust removal stickers if any dust particles become trapped between the protector and your device during the installation. Carefully lift up the corner of the protector closest to the particle, then place the sticky side of the strip against the speck of dust and pull the dust sticker straight out.
Can I use water to apply screen protector?
The key is to have the surfaces wet so you can apply the protector to the screen (sticky side down) and have just enough liquid so you can slide it into place. Once you have it in place, there is a small rubber squeegee to wipe away the solution.
How do you put on a dust absorber on a screen protector?
Use DUST ABSORBER sticky to gently tap on the glass in areas where you spot dust particles. DO NOT use sticky in the same way you use cloth/tissues – only tap and pull it back! It will leave glue traces if you try to wipe dust particles with the sticky tape! Use napkin with some Glass Cleaner liquid applied.
How do I get rid of bubbles under my screen protector?
Push Bubbles Out with a Plastic Card Instead, use a plastic card, preferably one with a clean, hard edge without nicks. Clean the card, too, like in the first step. Then, push out each bubble from the center to the edge of the screen. Also, push in one direction if you can.
Can I remove and reapply tempered glass?
Yes. You can remove the glass screen protector and reuse it. But you should not put it on a tape or take much time in re-fixing the screen on the top of your phone. In that case, the dust particles may accumulate on the glue of the screen glass as well as on the phone glass.